Comtek PR-216 Manual del operador descargar pdf (Pagina 15)

Page 13

Battery Charger

The NBC 9-2C charger supplied with the AT-216 system will recharge either

Nickel-Cadmium (Ni-Cad) or Nickel-Metal Hydride (Ni-MH) batteries.

Ni-MH batteries are supplied with the AT-216 system.

Note: Do not attempt to charge alkaline batteries with the NBC 9-2C charger.

To charge the AT-216 system, please take the following steps:

1. Make sure that rechargeable batteries are installed in the receiver and

transmitter. (Alkaline batteries must not be charged with the NBC 9-2C charger.

Alkaline batteries are only installed for initial use.)

2. Make sure that M-216 transmitter and the PR-216 receiver are turned off.

3. Insert the NBC 9-2C charger into a 115 volt AC outlet.

4. Plug the charger output cords into the output receptacle of the PR-216

receiver and auxiliary input receptacle of the M-216 transmitter.

(The red indicator on the receiver and the green indicator on the transmitter

should not be lit.)

5. Note that the red charging indicators on the NBC 9-2C should be lit.

6. Allow the batteries to charge for 12 hours, which provides 8 hours of

operation when Ni-MH type batteries are used.

Note: Excessive charging may reduce the life cycle expectancy and capacity

of the batteries. Batteries should never be charged more than 72 hours with

the NBC 9-2C charger.

Section 3 Battery Charger

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Sin comentarios

Comtek PR-216 Manual del operador Pagina 15